| To Part Two
 To Part Tree To Part Four Part One of Four Introduction Anke and I have just completed our first season's  cruising SLACKTIDE in SE Alaskan waters. She's a 26' x 7' x 1', engine-free,  junk ketch-rigged sailing barge of my design (plans and more pics at our  website). She's not one of those curvacious barge-babes, either, but a four-square  and unrepentant box barge. Years ago I read that it was once common to convert  smallish box barges, originally built to service bridges, into sailing cruisers.  My memory paraphrases the passage thus: These little  yachts, generally gaff-rigged and sporting leeboards, were surprisingly beloved  by their owners. They could be found tucked away in backwaters one would think  only accessible to more able vessels.1
  
                I think I read this in a book on  small boat conversions, but have lost the source. If you know it, please drop  me a line at  triloboats@gmail.com. --Thanks!  
 
                I skimmed that  passage in passing, along with its appealing pen and ink sketch of one,  anchored in obvious contentment. Interesting, but I'd never seen such a barge –  they seem to belong to times past. Yet the memory lay dormant for two decades  before pushing through the mud of my id. Being by nature a penny pinching breed of sloth, I  was finally led by circuitous routes back to the box barge. Plywood replaces  the planks of yore, but like their inspirators, TriloBoats are, as boats go,  extremely cheap and easy to build. But would they fulfill their promise under sail? Would they be capable  and lovable? SLACKTIDE was built to find out (and pssst... the short  answer is yes). SLACKTIDE incorporates several features ranging from  unusual to outright experimental. Our sea trials aimed to answer questions  about the viability of the following: 
                  She is a box barge – while there are  several examples of sailing box barges (ALMA,WEATHERFAX, et al.), I'm  aware of none that sail as general cruisers in anywhere near the range of  conditions found in SE Alaska. To my knowledge, she is the first of my larger  designs completed for sail. In particular, can she make good in moderate gale  conditions? Her  bottom is a trampoline structure – by this I mean there are no internal stiffeners over the large,  dead flat cabin sole (the inside of the hull). It's designed to flex.The  copper bottom plates were glued, not fastened – this was intended to avoid barnacle-likenail-heads.Her large, side-windows are little  more than a foot above the waterline.Her low foredeck is little more than two  feet above the waterline – this is to maximize the forward  windows, allowing good steering visibility from a sitting position, inside the  cabin.Her off-centerboards are arranged on  cable travellers – This  allows them to stow aft, clear of our views while at anchor.The mizzen mast is off-center – displaced over one foot to port.The junk topsail cut is unusual – inspired by Polynesian crab-claw rig.We've  added a SeaCycle ® Drive Unit for windless propulsion – this is like an outboard, but with rotary  pedals (like a bicyle's) in place of the motor.  
                Living Aboard: SLACKTIDE is intended for year-round, live-aboard  cruising, and we've been living continuously aboard, now, through four seasons. Her simple, flexi-space  interior is reminiscent of a luxurious tent, but with the addition of 270deg of  large windows, affording a kayak level view. I can't say enough about these! From  curious sea-lions spy-hopping for a peek into our living room, to hump-back  whales seen from point blank, to wide vistas of snow dusted peaks o'er-topping  autumn inflamed forest. HDTV? Who needs it? They have the effect of opening a  small space into the wide world. Claustrophobic friendly! A kneeling galley, with wood-stove for heat and cooking, spans the  forward end. All our day-to-day foodstuffs, spices and cooking gear are ready  to hand, backed up by refill stores in 'deeper', hold storage. The port drawer (a  glimpse can be seen in above photo) has a sliding 'bread-board' cover. It can  be drawn out and used for additional counter-space. Aft, a chest-of-drawers provides reasonable storage for clothes, books  and toys. The drawers are lidded, and can be drawn to serve as seats, tables or  shelves. The mid-cabin is a 10ft x 7ft platform on the inside  of the hull, insulated and cushioned by foam and carpet (you might say we live  in the bilge). Windows are double-paned and the cabin is fully insulated. A  project table folds out from the portside wall. A double-wide, self-inflating mattress bed folds  against the s'brd wall as a sofa, and bedding is stuffed into large,  upholstered pillow-cases for daytime lounging. 
                Raingear hangs outside, under the scuttle overhang,  and coats hang p&s of the companionway, well clear of bedding. Two large holds, separated from the cabin by water-tight bulkheads,  provide deep storage for food and gear, and contribute toward extra-positive  buoyancy. We try to carry a year's worth of staples at all times, so they have  to contain a pile o' stuff. Aft hatches are set level with the deck in case we  wish to sleep on deck. 
                  
                    |  | Making  Pizza for Five plus the Dog |  Anchor wells fore and aft let us deploy six anchors in many combinations.  Two Manson Supremes (way cool spade anchors) are ready to drop from bow rollers.  We pull by hand, and the well enables good posture and purchase for the haul. Line  is spilled into the well, leaving the foredeck clear while underway. I'm writing aboard, quite comfortably warm despite the outside temp of 17degF.  Our fire is banked for wood economy, so we're in sweaters, but I'm considering  taking mine off. All corners of the interior have remained dry and mildew-free,  despite this year's wet autumn. The insulation and double-panes have paid for  themselves handsomely. We once lived aboard a much smaller boat whose  interior was laid out in a similar manner, and very much liked it (with the  exception of raingear hung insufferably in the bed space). So it has been no  surprise that the extra room with better access to gear, not to mention the  windows, has proven comfortable. Like we've always said, “Our  home may be small, but the back yard is HUGE!” Sea  Trials took place in three legs totalling about 428 nautical miles, as the  Raven flies over water.  We sailed in and between Sitka and Salisbury sounds, through Sergious Narrows and Peril Strait, Into and out of Icy Strait, and up and down Chatham Strait and Lynn Canal. These are  challenging waters by any measure, and much of it was in autumn, a season rife  with gale and storm. Of course light air can also settle in for weeks at a  time, presenting its own challenges. 
                
                  |  | Anke and  I, with Friend's Luggage and Beer |  Please join us for the  next installments to hear how things went! **** This  four-part series of articles includes the following: 
                Introduction to SLACKTIDE and Living Aboard Leg I – Sitka to Warm Springs BayLeg II – Warm Springs Bay to HainesLeg III – Haines to Tenakee Springs  
                
 Please  check back at this site for the rest of the series. Thanks  to John Hirschenrider and Tom Krantz for their photos of SLACKTIDE under sail. SLACKTIDE and other designs, along with more articles and FAQ pages, can  be found at   www.TriloBoats.com Dave Zeiger © 2010  
 |